• IMPORTANT: Allow the Cooling Bowl to reach room temperature before cleaning.
• Use warm, soapy water to wash the Paddle, Splash Guard, Popsicle Container, Popsicle Mold,
Popsicle Sticks and Cooling Bowl. Dry thoroughly.
• Do not submerge the Cooling Bowl in water or other liquids.
• Wipe the Motor Base with a damp cloth and dry thoroughly.
• Never use any abrasive cleaning agents on the appliance as they may damage the Everyday
Ice Cream Maker.
TO DISASSEMBLE YOUR ICE CREAM MAKER
TO DISASSEMBLE YOUR POPSICLE MAKER
TO CLEAN
TIPS & TRICKS
1. Switch your Everyday Ice Cream Maker OFF and unplug the appliance before removing any parts.
2. Make sure the Paddle has come to a complete stop. Separate the Paddle by gently pulling it off the
Motor Base.
3. Squeeze the two clips at the bottom of the Motor Base until the Splash Guard is released.
1. Remove Popsicle Sticks
2. Separate Popsicle Container from Popsicle Mold.
CLEANING & MAINTENANCE
ISSUE SOLUTION
The ice cream is not freezing.
The Cooling Bowl was not cold enough. Make sure the Cooling
Bowl has been in the freezer for at least 8 - 10 hours. Do not remove
the bowl from the freezer until ready to use.
The Cooling Bowl may have a leak. Check to make sure the Cooling
Bowl is not damaged or punctured.
The paddle is jammed or
will not spin.
The Everyday Ice Cream Maker must be in operation with the
Paddle spinning BEFORE adding any ice cream mixture to the
Cooling Bowl. The motor must be set in motion while the Bowl is
empty. Then, the ice cream mixture should be poured through the
Ingredient Chute.
Ice cream may have frozen to the sides of the Cooling Bowl
causing the Paddle to get stuck or stop moving. If this occurs, turn
off the appliance, remove the Splash Guard and use a plastic or
wooden utensil to scrape the frozen mixture off the sides. Manually
mix the frozen areas into the rest of the mix then continue churning
once again.
The Everyday Ice Cream Maker is equipped with a safety feature
that automatically shuts off the machine if the motor overheats. This
may occur if the mixture becomes too thick causing the motor to
run for a long period of time. In the event of an automatic shut-off,
simply switch the appliance off, unplug and allow it to cool. You
may continue using the Everyday Ice Cream Maker once the ice
cream mixture has thinned.
After each use, the Everyday Ice Cream Maker should be cleaned properly. Before moving
or cleaning the unit, make sure the appliance is unplugged.
NOTE: This appliance is NOT dishwasher safe. Do not submerge Cooling Bowl or Power
Unit in any liquid. Do not put the Cooling Bowl in the freezer if wet.
TROUBLESHOOTING
• The nished dessert will be a soft texture but if you wish for a rmer result, store the
ingredients in a separate container inside the freezer for an hour.
• For faster results, refrigerate or freeze your ingredients prior to making your mixture.
∙ 16 ∙ ∙ 17 ∙
To Next Page
Loading...
Need help?
General
