STEP BY STEP
Press LEARN until you hear 2
beeps, when you release the
button, it will switch
automatically, and the door will
work in step by step.
A short beep indicates step-by-
step selection.
INVERSION TO CLOSURE
Press LEARN until you hear 2 beeps,
releasing it will change the setting.
In descent, if you press, it reverses
the maneuver without stopping.
A long beep indicates reversal
selection on closing
Press LEARN button until it beeps 4 times. This indicates the erasing
mode is activated. When releasing the button all channels and
remotes will be erased.
*Note: once the memory has been deleted, it is MANDATORY to
repeat option 1 for the correct functioning of the control board.
REMOTE PROGRAMMING
SELECT THE CORRESPONDING COMBINATION FOR THE DESIRED BRAND. SEE
TABLE
** THE RED BUTTON IS LOCATED ON THE RECEIVING BOARD (INSTALLED
PERPENDICULAR TO THE BOARD), LIKE THE LED.
MANEUVERS TIME PROGRAMMING
Before programming, check the correct instalation of the limit switches (in case
they are installed). The door must be closed.
The orders are given by pressing LEARN button or an already programmed
remote.
1. Select option 1 from the MENU: Press LEARN until you hear 1 beep (the
maneuver time programming mode has been activated).
To Next Page
Loading...