Page | 2
230 W Blueridge Ave, Orange CA 92865 | Telephone: 714-921-6000 | Fax: 714-921-6010
10. Connect the display module to the Expanded‐dap4 controller (J10 connector) using the factory
provided 35 ft. display cable. This cable looks similar to a telephone cable, but is not; do NOT
replace it with a standard telephone cable. Route this cable along unit’s frame, making sure the
cable does not get pinched by the door or panels.
11. Check all the wiring connections before restarting the unit.
12. Turn the unit power back on, and wait about 30 seconds for the Expanded dap4 to go through its
self-test. During this time, the backlit display will illuminate without text. After the self‐test, the
Expanded dap4 will display text. Press and hold the ESC key for 5 seconds to start the unit.
13. Check the Expanded dap4 for proper settings. Refer to dap4 IOM for programming details.
To Previous Page
Loading...
Need help?
General
