To Next Page

To Previous Page

46 Installing the USB Printer Driver

10. SelectthePrintermodelfromthelist.

 IfthisisthefirstSR200orSR300printerinstalledonthisPC,thedefaultprinteris

<name>U1.

 U1istheunitnumber,anditmustmatchtheUSBportyoucreate(refertostep 14)and

thePrintername.

 Usetheselectedprinternameasitisshownor,ifyouplantosharetheprinter,remove

thespaceinthenamesothatitdisplaysasSR‐CPU1.

 IfthisisnottheonlyUSB‐connectedprinteronthisPC,settheunitnumberoftheprinter

now.Referto“InstallingtheStatusMonitor”onpage 55.

11. SelecttheMakethisthedefaultprintercheckboxifyouplantouseonlythisprinterfrom

thisPC.ClickNext

12. Powerontheprinter.Continuewiththeinstallation.

ThedefaultprinternameistypicallyU1.Theunitnumberselectedheremustmatchthe

unitnumbersetontheprinter’sLCDpanel.(Re ferto“SettingtheUnitNumber,Printer

Name,andConnection”onpage 59tofindorchangetheprinter’sunitnumbersetting.)

Iftheprinterhasbeenusedbeforethisinstallation,makesurethattheunitnumberand

networknamecorrespond.Forexample,iftheprinterisU2,thenthenetworkprinter

namemustbePRINTER02.Iftheprinterwaspreviouslysettoprintoverthenetwork,

youcanchangethedefaultto

USBatthesametime.

DataCard LM200 Installation Guide

Other manuals for DataCard LM200