SECTION 1
1-1
001-4090-101/102
PRODUCT OVERVIEW
1.1 SCOPE OF MANUAL
This document provides information required for the operation and preventive maintenance of the
DATARADIO COR Ltd. Integra-H Spread Spectrum Radiomodem. This manual is intended for system designers,
professional installers and maintenance technicians
1.2 GENERAL DESCRIPTION
Integra-H is a high-speed protocol transparent radiomodem. It is designed specifically to fit the needs of
Supervisory Control and Data Acquisition (SCADA), telemetry and control applications. Integra-H provides the
communication links to data equipment for installations where wired communication is impractical.
Integra-H will work with most makes and models of remote terminal units (RTU) and programmable logic
controllers (PLC) and their protocols. Configuration settings allow tailoring for a variety of application
requirements.
Integra-H supports:
1. Point to point configuration in switched simplex mode
2. Point to multipoint configuration
Settings and connections for these configurations are given later in this manual
1.2.1 CHARACTERISTICS
Integra-H has the following characteristics:
l Selectable network speeds of 9600, 19200, 21400, and 25600 b/s
l One COM port for connection to DTE. Speed of 300 - 19200 baud
l One Setup port, for configuration and diagnostics output (speed fixed to 9600 baud, 8 bit, (unlicensed
frequency hopping band) no parity, 1 stop bit
l Built-in 0.1 - 1-watt transceiver, operating in the 902-928 MHz communications bands
l Fully transparent operation with error-free data delivery (no “dribble bits”)
l Allows transmission of “break” characters
l DOX (Data Operated Transmit) or RTS mode
l Two 8-bit analog inputs (0 - 10V)
l Low power consumption modes: “sleep” and “suspend” modes (< 20 mA)
l “13.3 VDC, negative ground” device
To Next Page
Loading...