Need help?Do you have a question about the Datavideo SE-2850 and is the answer not in the manual?
General| Chroma Key | Yes |
|---|---|
| DVE | Yes |
| Internal Stills | Yes |
| Talkback | Yes |
| Tally | Yes |
| Resolution | Up to 1080p |
| Frame Rate | Up to 60fps |
| Audio Outputs | 2 x XLR, 2 x RCA |
| Transition Effects | Cut, Mix, Wipe |
| Control Interface | RS-232, GPI |
| Power Supply | 12V DC |
| Audio | Embedded (SDI) |
Lists the key features and capabilities of the SE-2850 digital video switcher.
Details specific rear panel connections like inputs, sync, and outputs.
Explains how to perform video switching using the Program and Preset rows.
Describes the different video transition types and their controls.
Explains how to initiate video transitions using Speed, Auto Take, Cut, FTB, and T-Bar.
Explains the Picture-in-Picture (PIP) and Down Stream Keyer (DSK) functionalities.
Introduces the On-Screen Display (OSD) menu options for configuration.
Details OSD menu settings for video input standards, formats, and audio adjustments.
Explains how to remotely control the SE-2850 switcher using the SE Remote software.
Describes the SET function for matching the SE Remote software to the switcher's IP address.
Explains the REC, PLAY, Macro, and Time functions within the SE Remote software.
Details the steps for network setup and assigning a static IP address to the PC.
Provides instructions on connecting the SEConfig software to the SE-2850 switcher.
Explains how to change the SE-2850 switcher's IP address using the setup utility.
Describes the 'Switcher' tab for setting up connection methods.
Details the 'Settings' tab for configuring various switcher menu options.
Details the configuration settings for video inputs 1 to 12.
Details the audio configuration settings for inputs 1 to 12.
Details the configuration of video crosspoints (XPT) for input sources.
Provides instructions and requirements for updating the SE-2850 firmware.
To Next Page
