Product Manual and User Guide
Setting up your PowerBase for Pokémon
PowerBase for Pokemon requires an internet connection to be able to provide codes and saves for
your 3DS Pokemon games.
Setup with WPS
1. Plug your PowerBase into a power source
using the cable provided.
2. Press WPS button on your router.
3. Press and hold down the right hand button on
your PowerBase for 3 seconds until the
blue light goes out.
4. Wait (up to) 30 seconds for the blue light to come
back on and stay lit.
5. Open up the PowerBase app at https://pokemon.powersavesplus.com/
6. The PowerBase Device Key will automatically appear in the the required section.
7. You will need a CodeJunkies account* to use your PowerBase device.
Setup with Wi-Fi
1. Plug your PowerBase into a power source using the cable provided.
2. Connect to its Wi-Fi network designated PowerSaves‘XX’ where ‘XX’ is replaced by your
unique PowerBase Device Key.
3. Connect to this network using your device.
4. Once connected, please open a web browser and navigate to 192.168.4.1
5. Enter select your Wi-Fi network and enter its password.
6. Open up the PowerBase app at https://pokemon.powersavesplus.com/
7. The PowerBase Device Key will automatically appear in the required section.
8. You will need a CodeJunkies account* to use your PowerBase device.
What’s in the box?:
x1 AR PowerBase Unit
x1 Power Cable
x1 License Key
x1 Micro SD Media Card
L
R
License Key
xxxx-xxxx-xxxx-xxxx-xxxx-xx
V1.1
To Next Page
Need help?
General
