When ArpLatch is set to Normal and latch is on, pressing one or more keys and
then removing your hands from the keyboard will latch the played notes.
Playing additional notes while latched adds them to the notes already playing.
When ArpLatch is set to ReLatch, pressing one or more keys and then removing
your hands from the keyboard will latch the played notes. Subsequent notes or
chords played will cause the previously latched notes to stop playing and be
replaced by the newly played note(s). While one or more keys is held, playing
additional notes will add them to the latched notes.
To turn latch off, press A
RPEGGIATOR again.
The Arpeggiator can also be latched with a footswitch connected to the Sustain
jack. See “Sustain” in Global Parameters on page 8.
The Arpeggiator (and Sequencer) can sync to MIDI clock from an external
sequencer or other device. See “Clock” in Global Parameters on page 8 for
more information.
Sequencer—Turns Mopho x4’s gated sequencer on and off. See Sequencer on
page 20 for more information.
BPM: 30…250—Sets the tempo for the sequencer in BPM (beats per minute).
The accompanying light flashes on the beat. When syncing to an external MIDI
clock source, the BPM control has no effect.
Clock Divide—Sets the note value for each sequencer or arpeggiator step
relative to the BPM. Also affects the LFO frequency when LFO Clock Sync is
on. C
LOCK DIVIDE works with both internal and external clock sources. The
following table lists the C
LOCK DIVIDE values.
To Next Page
Loading...
