Davey Torrium 2 TT45 User Manual

2
Congratulations on your purchase of a high quality, Australian built Davey Torrium2
controller. All components have been designed and manufactured to give trouble free,
reliable operation.
Prior to using this controller you must ensure that:
• The controller is installed in a safe and dry environment
• The controller enclosure has adequate drainage in the event of leakage
• Any transport plugs are removed
• The pipe-work is correctly sealed and supported
• The pump is primed correctly
• The power supply is correctly connected
• All steps have been taken for safe operation
Appropriate details for all of these items are contained in the following Installation and
Operating Instructions. Read these in their entirety before switching on this controller. If
you are uncertain as to any of these Installation and Operating Instructions please contact
your Davey dealer or the appropriate Davey ofce as listed on the back of this document.
Your Torrium2 controller is an electronic ow control device – a Davey designed product
that enables the use of a highly efcient pump design and offers the following benets:–
1. Enables the pump to deliver a constant ow of water particularly at low ow rates –
reducing the inconvenience of pressure variation in showers etc.
2. Provides automatic “cut-out” protection should the pump run out of water or overheat*,
should the pump fail to start due to low voltage or a blockage in the pump.
3.
Provides an easy to understand visual representation of the system status.
4. Has adaptive pressure cut-in which allows the pump to start at approximately 80% of the
maximum pressure at last shut-down. This allows the controller to accommodate varying
inlet pressures and pump performance.
Torrium2 model TT45/M has a xed cut-in pressure of 150kPa; Torrium2 model TT70/M
has a xed cut-in pressure of 250kPa
5. Automatic retry functions in the event of a critical system fault.
6. Easy visual guide to the status of the inbuilt surge arrestor.
7. Choice of both vertical and horizontal outlets.
* Motor overload / overheat protection is also included. Motor must also have its own
overload / overheat protection.
Before installing your Torrium2 controller, please read all instructions carefully as failures
caused by incorrect installation or operation are not covered by the guarantee. Your Torrium2
controller is designed to handle clean water. The system should not be used for any other
purpose without specic referral to Davey. The use of the system to pump ammable, corrosive
and other materials of a hazardous nature is specically excluded.
WARNING: Some insects, such as small ants, nd electrical devices
attractive for various reasons. If your pump enclosure is susceptible
to insect infestation you should implement a suitable pest control plan.
DO NOT USE THREAD SEALING COMPOUNDS, HEMP OR PIPE DOPE!

Davey Torrium 2 TT45 Specifications

General

Brand	Davey
Model	Torrium 2 TT45
Category	Controller
Language	English