Davey Torrium 2 TT70

Please pass these instructions on to the operator of this equipment.
WARNING: The Torrium2 controller, pump and associated pipework operate
under pressure. Under no circumstances should the Torrium2 controller, pump
or associated pipework be disassembled unless the internal pressure of the
unit has been relieved. Failure to observe this warning will expose persons to
the possibility of personal injury and may also result in damage to the pump,
pipework or other property.
WARNING: Failure to follow these instructions and comply with all applicable codes
may cause serious bodily injury and/or property damage.
NOTE: Prior to installation remove the inlet and outlet
pipe transport plugs & associated seals from the suction
and/or discharge ports.
Pressure System Controller
Installation and Operating
Instructions

Davey Torrium 2 TT70 Specifications

General

Type	Controller
Pump Type Compatibility	Submersible and Surface Pumps
Max Flow Rate	70 L/min
Maximum Water Temperature	60°C
Maximum Ambient Temperature	50°C
Maximum Load Current	10 A
Operating Temperature	0°C to 50°C
Model	Torrium 2 TT70
Power Supply	220-240V AC, 50Hz
Inlet/Outlet Size	1 inch
Input Voltage	220-240V AC
Output Voltage	220-240V AC
Protection	Overload

Summary

Controller Selection and Fitment

Model Selection

Choosing the correct Torrium2 model based on pump system specifications and voltage requirements.

Installation and Fitment

Guidance on installing the Torrium2 controller onto the pump and ensuring proper fitment.

Installation Procedures

Direct Pump Fitting

Instructions for fitting the Torrium2 directly to pumps with 1-inch female or male outlets.

Adaptor Flange Fitting

Procedure for fitting the adaptor flange to earlier Hydrascan and Torrium models.

Extra Draw-off Capacity

Guidance on installing additional accumulator capacity for increased draw-off.

System Operation and Connections

Low Flow Application Setup

Adapting Torrium2 for evaporative coolers, RO filters, and other low-flow devices.

Suction Line Considerations

Guidance on suction lines, including flooded suction and suction lift installations.

Discharge Port Options

Connecting discharge pipework to horizontal or vertical outlets.

Plumbing and Electrical Installation

Pipe Connection Guidelines

Recommendations for pipe material and diameter for optimal controller performance.

System Priming Instructions

Steps for priming the pump and system using the priming plug and check valve.

Power Connection Safety

Guidelines for safe and correct electrical connection of the Torrium2 controller.

Controller Status and Protection

Status Indicator Lights

Explanation of indicator lights for monitoring operating conditions and system faults.

Electrical Surge Protection

Information on surge protection and the status window for the MOV component.

Maintenance and Troubleshooting

Regular Maintenance

Scheduled checks for pressure tank air charge and lubrication during servicing.

Troubleshooting Common Issues

Diagnosing and resolving common pump and controller problems based on indicators.

Davey Warranty Information

Warranty (USA)

Details of the warranty terms and conditions for products sold in the USA.

Warranty (Outside USA)

Details of the warranty terms and conditions for products sold outside the USA.