Davey Torrium2 User Manual

Your Torrium2 controller is an electronic ow control device – a Davey
designed product that enables the use of a highly efcient pump design and
offers the following benets:–
1. Enables the pump to deliver a constant ow of water particularly at
low ow rates – reducing the inconvenience of pressure variation in
showers etc.
2. Provides automatic “cut-out” protection should the pump run out of
water or overheat*, should the pump fail to start due to low voltage or a
blockage in the pump.
3. Provides an easy to understand visual representation of the system status.
4. Has adaptive pressure cut-in which allows the pump to start at
approximately 80% of the maximum pressure at last shut-down. This
allows the controller to accommodate varying inlet pressures and pump
performance.
5. Automatic retry functions in the event of a critical system fault.
6. Pressure indicator so you can easily tell what the pressure in your water
supply system is doing.
7. Easy visual guide to the status of the inbuilt surge arrestor.
8. Choice of both vertical and horizontal outlets.
* Motor overload / overheat protection is also included. Motor must also
have its own overload / overheat protection.
Before installing your Torrium2 controller, please read all instructions carefully as
failures caused by incorrect installation or operation are not covered by the guarantee.
Your Torrium2 controller is designed to handle clean water. The system should not be
used for any other purpose without specic referral to Davey. The use of the system to
pump ammable, corrosive and other materials of a hazardous nature is specically
excluded.
2 15
Congratulations on your purchase of a high quality, Australian built Davey
Torrium2 controller. All components have been designed and manufactured
to give trouble free, reliable operation.
Prior to using this controller you must ensure that:
• The controller is installed in a safe and dry environment
• The controller enclosure has adequate drainage in the event of leakage
• Any transport plugs are removed
• The pipe-work is correctly sealed and supported
• The pump is primed correctly
• The power supply is correctly connected
• All steps have been taken for safe operation
Appropriate details for all of these items are contained in the following
Installation and Operating Instructions. Read these in their entirety
before switching on this controller. If you are uncertain as to any of these
Installation and Operating Instructions please contact your Davey dealer or
the appropriate Davey ofce as listed on the back of this document.

Davey Torrium2 Specifications

General

Brand	Davey
Model	Torrium2
Category	Controller
Language	English