1
Sensor Mounting Shelf
for Vantage Pro® and Vantage Pro2™
The Sensor Mounting Shelf is for use with the Integrated Sensor Suite (ISS) of the
Vantage Pro and Vantage Pro2. The shelf has mounting provisions for a Solar Radi-
ation Sensor and an Ultraviolet Radiation (UV) Sensor. This manual contains
instructions for installing the shelf on the ISS. Please refer to the appropriate sensor
installation manual for instructions on mounting sensors.
Components
The Sensor Mounting Shelf includes the following components:
Please Note: There are two types of Sensor Mounting Shelves, one black plastic (product number
6673) and one white aluminium (product number 6672). Both shelf types use the same installation
instructions, and they are functionally identical.
Tools for Setup
To install the Sensor Mounting Shelf you will need a medium Phillips screwdriver.
Sensor Mounting Shelf
Support
Tubes
#10-24 x 7-3/4" Screws
#10 Flat Washe
#10 Lock Washe
#10-24 Nuts
4" Cable Ties
Cable Clamps
#4 x 3/8"
elf-tapping Screws
#4 Flat Washers
To Next Page
Need help?
General
