To Next PageTo Next Page
Need help?Do you have a question about the Dawlance Econo Plus 15 and is the answer not in the manual?
General| Energy Efficiency Ratio (EER) | 2.8 |
|---|---|
| Compressor Type | Rotary |
| Type | Split |
| Color | White |
| Voltage | 220-240V |
| Frequency | 50 Hz |
| Cooling Capacity | 15000 BTU |
General warnings about installation and operation causing harm or damage.
Explains Warning (death/injury) and Caution (injury/damage) symbols.
Appliance use by children and persons with reduced capabilities.
Requirements for grounding, power cords, and circuit protection.
Guidelines for unplugging, avoiding water, flammable gases, and lightning.
Avoiding unauthorized repairs and ensuring proper installation and clearances.
Details on refrigerant types and WEEE disposal instructions.
Precautions on air circulation, unit placement, and temperature settings.
Requirements for supply cords, switches, and RCDs for fixed wiring.
Temperature ranges for cooling/heating and potential issues.
Using the force switch and adjusting airflow direction.
Details on fan start-up, defrost cycles, and vapor emission.
Identifies parts of the indoor unit like air inlet, filter, and panel.
Identifies parts of the outdoor unit like air inlet, outlet, and connecting pipes.
Safety precautions before cleaning the air conditioner.
Instructions for cleaning the indoor unit's panel.
Steps to remove, clean, and dry the air filter.
Reinstalling the air filter after cleaning.
Pre-operation checks for inlets, outlets, drain pipes, and grounding.
Post-operation maintenance steps, including power off and cleaning.
Lists common phenomena and their causes/solutions.
Actions to take for abnormal sounds, heat, or electrical issues.
Importance of professional installation and location selection.
Requirements for mounting racks and installation at heights.
Requirements for power supply, circuits, protection devices, and grounding.
Wiring diagrams, fuses, and model rating information.
Contents included with the indoor unit.
Contents included with the outdoor unit.
Diagram showing clearance requirements for indoor unit installation.
Steps for securely installing the mounting plate for the indoor unit.
Instructions for creating and protecting wall-through holes for piping.
Guidance on routing the piping and power cord for the indoor unit.
Instructions for connecting the drain pipe and tightening nuts.
Steps for insulating and securing pipes, cables, and drain hose.
Steps to hang and securely attach the indoor unit to the mounting board.
Explains different wiring configurations for various unit types.
Clearance requirements and bolt size information for installation.
Steps for connecting pipes, wiring, and calculating refrigerant.
Method for discharging refrigerant and air from the outdoor unit.
Procedure for evacuating air using a vacuum pump for R410A.
Electrical, installation, and leak checks after unit setup.
Steps before starting the test operation, like battery installation.
How to perform the initial test run and select modes.
Installation of the drain elbow for heat pump type condensation.
