DAYE DG600 - 3 in 1 Features; Starting Operation; ONE: Retrofitting for Mulching Mower

8
Apply outward pressure to disengage the lever from the rack. Move the lever forward or back to adjust the height of cut. (Fig. 5
and see clause 7.9)
Fig. 5
6. “3 IN 1”
The lawn mower has 3 in 1 features:
1. Rear grass collection.
2. Grass mulching.
3. Side-discharge.
What is mulching?
When mulching, the grass is cut in one working stage, then finely chopped and returned to the grass strip as natural fertiliser.
Recommendations for mulch-mowing:
- Cut your lawn regularly. Cut-back by a maximum of 2cm from grass of 6cm height.
- Ensure the blade is sharp for best results - Do not mulch wet grass.
- Set maximum engine speed.
- Only move at a walking pace.
- Regularly clean mulching wedge, housing inner side and mowing blade.
Starting Operation
ONE: Retrofitting for mulching mower
WARNING: Only with a stopped engine and when the blades have completely stopped.
1. Raise the rear cover and remove the grass catcher
2. Push the mulching wedge into the deck. Lock the mulching wedge with the button into the opening on the deck. (Fig.6A/Fig
6B)
3. Lower the rear cover again.
Fig. 6A Fig. 6B
TWO: Resetting for side-discharge mowing