Daymak EM2 - Technical Data

18
Technical Data
This section provides you with the technical specications for your e-bike.
The Motor and Wheel Assembly
The EM2 has a 500 Watt magnetic DC brushless motor on the rear wheel hub. This type of motor has excel-
lent low-end torque and high eciency when working within its range. Note that while the motor is very
quiet, it does produce some noise. Also attached to the rear hub are speed reduction gear and the speed
free clutch.
The Freewheel
The wheels have freewheels, so the e-bike’s drive train is not xedly geared. This means that when coasting
or traveling downhill, you can turn o the engine and your e-bike will continue to move without slowing.
This feature will allow you to achieve faster speeds when coasting, moving downhill or moving with the
wind. It will also allow you to conserve electrical power, because you will be able to let to the motor rest
while moving.
The Controller
Daymak pioneered the development of intelligent component control in e-bikes. The Daymak Drive tech-
nology developed by Daymak is the brain of your e-bike. It allows your e-bike to achieve faster acceleration,
to climb steeper hills, and to save energy.
The electronic controller is located under the seat assembly. This controller eciently regulates the speed
and electronic functions of the bicycle. It allows for stepless speed adjustment, shuts o the motor when
the brakes are activated, has low voltage protection and has fuses to prevent excess current from damaging
the e-bike’s systems.