14
Operation
Right handle bar
1) Front Brake - is engages the front brake,
use this only aer the rear brake has been en-
gaged for additional stopping power.
2) rottle - Turn this towards you to engage
the motor to go!
3) 3 Speed Switch - Turn this to easily monitor
your speed. Speed 1 - Slowest speed / Longest
Range Speed 3 - Fastest Speed / Shortest Range
4) Cruise Control - Once you have a set speed
press this button to retain this speed without
using the throttle.
5) Horn - Press this to Honk the horn
6) Lights - e far right position is all lights o. e Middle Position is just running brake lights and far
le position is all lights on.
7) Motor Kill Switch - If the switch is up the motor will not work, if it is down the motor will engage.
1) Turn Signals - Press to the le to signal
turning le. Push to the middle once done
turning. Push to the right to signal turning
right.
2) Horn - Horn for honking
3) High Beam / Low Beam - Press up to an-
gle your lights hight and press down to angle
the lights down.
To Next Page
Loading...
