51
INGENIA IG2T Cod. 420120238 REV. 1.1
USE OF A PAIR OF STACKED IG2T SPEAKERS
To properly couple and then use two stacked IG2T speakers, you need a pair of LP-IG connecting brackets. For
further details please refer to the instructions of this accessory.
Once the two speakers are properly mounted, the infra-red detection system installed on the handles activates
automatically; the user will just have to run the check in the initial conguration menus, that will be discussed in
the next chapter.
ATTENTION!
• Only 2 identical speakers can be installed, interconnected and detected
through the infra-red ports.
• Never use the handles to suspend the speaker!
TOP
BOTTOM
TOP
BOTTOM
English
To Next Page
Loading...
