13
C. WORKING POSITIONING: Anchorages selected for work
positioning systems shall have a strength capable of sustaining
static loads applied in the directions permitted by the system
of at least:
1. 3,000 lbs. (13.3 kN) for non-certied anchorages, or
2. Two times the foreseeable force for certied anchorages.
When more than one work positioning system is attached to
an anchorage, the strengths set forth in (1) and (2) above
shall be multiplied by the number of systems attached to the
anchorage.
D. RESCUE: Anchorages selected for rescue systems shall have
a strength capable of sustaining static loads applied in the
directions permitted by the system of at least:
1. 3,000 lbs. (13.3 kN) for non-certified anchorages, or
2. Five times the foreseeable force for certified anchorages.
When more than one rescue system is attached to an
anchorage, the strengths set forth in (1) and (2) above shall
be multiplied by the number of systems attached to the
anchorage.
E. CLIMBING: The structure to which a climbing system
is attached must sustain the loads required by that
particular system. See instructions for climbing system for
requirements.
3.0 DONNING AND USE
WARNING: Do not alter or intentionally misuse this equipment. Consult
DBI‑SALA when using this equipment in combination with components or
subsystems other than those described in this manual. Some subsystem
and component combinations may interfere with the operation of this
equipment. Use caution when using this equipment around moving
machinery, electrical and chemical hazards, and sharp edges.
Figure 9 - Front and Back View of ExoFit Vest Style Full Body Harness
Front
Back
Belt Loops
To Next Page
Loading...
