13
Problems Solutions
1. No power - Unit is turned off.
- Check if the batteries are installed properly.
- Make sure the adaptor is connected to the Unit properly if using
the adaptor instead of batteries.
- The Unit may be in low battery status, change new batteries.
2. Message not
transmitted.
- Sound sensitivity level of Baby unit is too low, turn the sound
sensitivity switch to “HI” position.
- Units are out of range or lost connection. Ensure the distance
between the units within 300m.
Note: Communication range varies depending on surrounding
conditions such as physical obstructions, interference.
- Make sure the TALK key of Parents unit is not pressed.
- Make sure the unit is unlocked.
- Ensure both units have already scanned the corresponding
code.
3. No sound signal - Volume level on Parents unit is set too low. Adjust it to higher
volume.
- Sound sensitivity level of Baby unit is too low, Turn the
Sound Sensitivity switch to“HI” positions.
- Units are out of range. Ensure the distance between the units
within 300m.
- Make sure the TALK key of Parents unit is not pressed.
- Make sure the unit is not locked key.
- Ensure both units have already scanned the corresponding
code.
4. Received
Conversation or
sound from neighbors.
- Signal interference due to other nursery monitor on the same ID
Code or cordless phone used.
- Change both units to another ID code by pressing LINK key.
5. Hearing static or
rustle from Parent unit.
- The both units are positioned too close to each other. Keep away
two units at about 1m.
- The volume is set too high. Lower the volume at the Parent unit.
- Reposition or replace batteries.
Technical Specifications
Power Supply Voltage:
Parents unit : 3 AAA batteries or rechargeable batteries & Adaptor: AC120V, DC 7.5V
Baby unit : 3 AAA batteries or rechargeable batteries & Adaptor: AC120V, DC 7.5V
Operation Frequency : 2.401~2.482GHz
Operating Range: up to 300m in ideal conditions
Mic Sensitivity : 1 to 2 meter
To Next Page
Loading...