DC DC1300 - User Manual

OPERATION
• REMOVE ALL DEBRIS FROM THE ITEMS TO BE WASHED, BEFORE PLACING THEM INTO THE BASKET.
• SELECT THE WASHING CYCLE TIME SWITCH - 1` 2` OR 3` MINUTE.
• CLOSE DOWN THE HOOD, THE WASHING CYCLE WILL START AUTOMATICALLY AND THE CYCLE LAMP WILL COME ON.
• AT THE END OF THE CYCLE THE CYCLE LAMP WILL GO OUT.
• ALLOW A FEW SECONDS FOR THE WATER TO RETURN TO THE WASH TANK BEFORE LIFTING UP THE HOOD.
• SLIDE OUT THE BASKET AND ALLOW EXCESS WATER TO RUN OFF BEFORE REMOVING.
PREPARATION
• CHECK DRAIN PLUG IS PUSHED FIRMLY IN PLACE AND FILTER AND SURFACE FILTER ARE CORRECTLY POSITIONED.
• CHECK DETERGENT ( RED ) AND RINSE AID ( CLEAR ) SUPPLY TUBES, WITH FOOT VALVES - ARE
SUBMERGED IN SUFFICIENT PRODUCT.
• CHECK THE HOOD IS CLOSED DOWN AND PRESS THE POWER SWITCH - THE POWER GREEN LAMP WILL COME ON.
• ALLOW 35 MINUTES FOR THE MACHINE TO REACH THE CORRECT WASHING TEMPERATURE.
OPERATING AND MAINTENANCE INSTRUCTIONS
DC1300
ROUTINE MAINTENANCE
• AT THE END OF A SESSION TURN OFF THE POWER SWITCH, COLLECT THE DEBRIS INTO THE FILTER BOX AND REMOVE.
• REMOVE THE SURFACE FILTER AND CLEAN THOROUGHLY.
• DO NOT ALLOW DEBRIS TO GO DOWN INTO THE LOWER WASH TANK.
• REMOVE THE DRAIN PLUG - THE WASH TANK WILL EMPTY.
• IF YOUR MACHINE IS FITTED WITH A WASTE PUMP - TURN OFF THE POWER SWITCH AND REMOVE THE
DRAIN PLUG - THEN PRESS AND HOLD THE WASTE PUMP SWITCH UNTIL THE WASH TANK IS EMPTY.
• DO NOT REMOVE LOWER WASH TANK FILTER OR ( IF FITTED WASTE PUMP FILTER BOX - OPTIONAL ) AT THIS STAGE.
• CLEAN AROUND THE LOWER WASH TANK AND INSIDE THE HOOD WITH AN 'ADDIS'’ TYPE WASHING UP BRUSH.
• DO NOT ALLOW DEBRIS TO GO DOWN THE OUTLET HOLE AS THIS MAY DAMAGE YOUR MACHINE.
• THOROUGHLY CLEAN AND REPLACE THE LOWER WASH TANK FILTER - REPLACE THE SURFACE FILTER & FILTER BOX.
• REGULARLY CHECK RINSE JETS AND WASH JETS ARE CLEAR OF DEBRIS OR LIME SCALE - REMOVE IF NECESSARY BY
UNSCREWING THE RINSE ARM NUT - REMOVE WASH ARM CLEANING CAPS - CLEAN THOROUGHLY AND REASSEMBLE.
• YOUR WATER SOFTENER ( IF FITTED ) SHOULD BE REGENERATED ONCE A WEEK OR ACCORDING TO INSTRUCTIONS.
SERVICE TEL.
directcateringproducts.co.uk
SERVICE CALLS TO RECTIFY FAULTS CAUSED BY `THE LACK OF ROUTINE MAINTENANCE` WILL BE CHARGED FOR
AND YOUR WARRANTY MAY BE AFFECTED
SWITCH LAMP 1` 2` OR 3` MINUTE WASTE PUMP SWITCH TEMPERATURE DISPLAY TEMPERATURE DISPLAY
POWER CYCLE CYCLE TIME SWITCH (OPTIONAL) WASH TANK BOILER
RINSE ARM NUT
RINSE JETS
WASH JETS
CLEANING CAP
FOOT VALVES
SURFACE FILTER
LOWER WASH TANK FILTER
OUTLET HOLE
DRAIN PLUG
FILTER BOX
(OPTIONAL)
WASTE PUMP
FILTER BOX

Summary

Operating Instructions

Preparation Steps

Check drain plug, filter, supply tubes, and hood. Allow 35 minutes for the machine to reach washing temperature.

Washing Operation

Remove debris, select cycle time, close hood to start. Allow water to return before unloading the basket.

Routine Maintenance Tasks

Clean filters, drain tank, clean jets, and maintain water softener. Turn off power before cleaning.

Installation Guide

Location and Machine Preparation

Verify electrical connections, check space, clear location, and remove protective plastic covering.

Water Supply Connection

Connect cold water hose to a shut-off tap. Use an extra hose for water softener connection.

Waste Water Disposal

Connect waste hose to outlet or stand pipe, using a running trap for gravity or pumped waste.

Electrical Connections

Connect the mains cable according to machine specifications. Use a qualified electrician.

Pre-Test Procedure

Turn on water and power supply. Check wash tank fills and boiler heats up correctly.

Detergent and Rinse Aid Adjustment

Prime and adjust dosing pumps for detergent and rinse aid for optimal washing results.

Commissioning the Machine

Adjust boiler temperature, run cycles, check pump activation, and monitor temperatures.

DC DC1300 Specifications

General

Brand	DC
Model	DC1300
Category	Dishwasher
Language	English