What to do if the monitor fuse blows when plugging in my DCS Microwave Oven?
If the DCS Microwave Oven becomes inoperative due to a blown monitor fuse, inspect the monitor switch, relay (RY1) primary interlock relay (RY2), door sensing switch, and secondary interlock switch before replacing the fuse. When replacing the monitor fuse, replace the monitor switch as well, using part FFS-BA016/KIT as an assembly.
General| Brand | DCS |
|---|---|
| Model | MO-24SS |
| Category | Microwave Oven |
| Language | English |
Steps to take before starting service procedures on the microwave.
Procedures to follow after completing testing on the unit.
Steps to perform after completing repairs on the unit.
Specifies the required limits for microwave leakage measurements.
Outlines the necessary steps before conducting leakage measurements.
Details the procedure for conducting a closed-door leakage test.
Explains the sequence of component functions during oven operation.
Details the power level operation for variable cooking modes.
Describes the steps to initiate and perform sensor cooking.
Electrical schematic showing the oven in its off state.
Electrical schematic showing the oven during cooking.
Explains the operation of the oven door opening mechanism.
Details the function of door sensing and interlock switches.
Describes the function and operation of the monitor switch.
Explains the function of the turntable motor.
Describes the function of the cooling fan motor.
Explains the purpose and blow conditions of the monitor fuse.
Details the function of the cavity temperature fuse.
Explains the function of the magnetron temperature fuse.
Lists potential causes and defective parts for various operating conditions.
Identifies procedure letters for component testing.
Details component testing procedures.
Steps for testing the magnetron assembly.
Procedure for measuring microwave output power using a water test.
Steps for testing the power transformer.
Procedure for testing the high voltage rectifier.
Steps for testing the high voltage capacitor.
Procedure for testing the cavity temperature fuse.
Steps for testing the magnetron temperature fuse.
Procedure to test the secondary interlock switch.
Tests for door sensing switch and primary interlock relay.
Procedure for testing the monitor switch.
Steps to diagnose issues related to a blown monitor fuse.
Procedure for testing the touch control panel assembly.
Various component tests including key unit and control unit.
Procedure for testing the key unit of the control panel.
Testing procedures for relays RY1 and RY2.
Procedure to test the Compu Defrost function.
Checks and repairs of the foil pattern on the printed wiring board.
Procedures for testing the Absolute Humidity (AH) sensor.
Methods to determine if the AH sensor or control unit is defective.
Steps to check the functionality of the control unit.
Overview of the touch control panel's components and functions.
Guidelines for handling sensitive electronic components like CMOS LSI.
Procedures for servicing the touch control panel.
Lists the necessary tools for servicing the touch control panel.
Additional precautions to take during touch control panel servicing.
Describes the physical structure of the absolute humidity sensor.
Explains how the absolute humidity sensor operates.
Details the detector circuit for the absolute humidity sensor.
Servicing the touch control panel when it's connected to the oven.
Servicing the touch control panel when separated from the oven.
Procedure for servicing the touch panel using an external power source.
Critical warnings regarding high voltage hazards during servicing.
Safety precautions related to wiring during servicing.
Step-by-step instructions for removing the outer case.
Lists all electrical components of the microwave oven.
Lists the external cabinet and structural components.
Lists components related to the control panel assembly.
Lists internal oven components and accessories.
Lists all parts associated with the oven door assembly.
Lists miscellaneous items and labels included with the oven.
Details the types and quantities of screws, nuts, and washers.
To Next Page
