11
EN
Installation instructions
Fig.5 Uneven door alignment
6. Leveling the refrigerator door
6
If doors are uneven, do the following:
a
Determine which door needs to be raised.
b
Turn the front roller adjustment screw (
a,
Fig.3
)
on that side clockwise to raise front corner of door.
c
If one adjustment screw has reached the limit of its
adjustment range and the doors are still not level,
lower the opposite door by turning the roller
adjustment screw counterclockwise.
d
Check with level to verify ⁄” (10 mm) tilt to the back
for proper door closure.
e
Once refrigerator is aligned, screw feet firmly in place
and attach toe grille (refer to step 5d).
7. What to do if the product is unstable
7
Gently pull the refrigerator forward and screw down the
feet until they make contact with the floor.
8
Push the refrigerator back until the rear rollers contact
the floor.
a
Measure the gap under the front foot, which has come
off the floor.
b
Obtain some solid packing material (hardwood,
plastic, etc), which fits firmly into the gap under
the foot.
Note: do not use metallic materials that may corrode,
stain and/or damage floor coverings.
This foot lifts off the floor when
top front is gently pushed back
Example only
Un-level floor
Fig.6 Unstable refrigerator
To Next Page
Loading...
