DDM 9004 User Manual

ddm
T u n i n g
ddm
ddm
T u n i n g
DDM INSTALL GUIDE 9004/9007 HID Low Beam Kit (35W or 55W)
TOOLS NEEDED: None
Remove the OEM bulb from the headlight
housing. To do so, remove the bulb locking
ring by twisting it counter clockwise, which
will release the bulb from the housing.
Remove the bulb locking ring on the low
beam by simultaneously unclipping and
pulling the connector away from the bulb.
DIFFICULTY: Easy Professional Install
PH
8
8
5
5
8
8
5
5
6
6
5
5
1
1
7
7
4
4
2
2
I
I
D
D
D
D
M
M
TUNING.COM PAGE 1/3
R
R
E
E
A
A
D
D
F
F
I
I
R
R
S
S
T
T
:
:
Most 9004/9007 kits ar
e relatively easy to install. Usually removal of
the headlight isn’t necessary. If removal of the headlight assembly is necessary
please refer to your vehicle’s owners manual for instructions. Note: We are using
a 1997 Jeep Cherokee for our install.
1
2

DDM 9004 Specifications

General

Brand	DDM
Model	9004
Category	Automobile Accessories
Language	English

Summary

HID Low Beam Kit Installation Guide

Tools and Preparation Notes

Details on required tools, installation difficulty, and important pre-installation notes for the HID kit.

Remove Existing Bulb

Step-by-step guide to safely remove the original halogen bulb from the headlight housing.

Connecting the HID System

Connect Adapter Cables to OEM Supply

Plug the new HID adapter cables into the vehicle's original low beam power supply connector.

Install New HID Bulb

Insert the new HID bulb into the headlight housing and secure it properly.

Finalizing the HID Installation

Connect Ballast and Secure Wiring

Connect the ballast to the HID bulb and adapter cables, ensuring all connections are secure.

Mount Ballasts and Verify Installation

Securely mount the ballasts in a suitable location and confirm the HID setup is correctly installed.