207
2 3
Lay the rst sleepers into the gaps
between the ballast pieces, starting
at the front. It does not matter which
way round the parts go.
Now begin tting the rail fasteners. Each
one has two pins on its underside, which
will t into the sleepers’ holes, as shown.
Fit all the fasteners.
4
Do this for
all the rails,
making sure
there is no
visible gap
where the
paired longer
rails meet.
The above photo shows where the long and short
rails will go.
The rails will be
tted by sliding
them through
the fasteners,
one by one.
6 14
Lay six at the front, and 14 at the rear, in each of the thinner ballast holes.
Short x 2
Long x 4
Complete
To Previous Page
Loading...
