20
8
21
19
Flap Servo
4
2 x 12mm Screw
Rod adjuster
Horn
2
4
2
2 x 60mm Rod
8
2 x 8mm
TP Screw
NO:1006 (M4)
6
Hard wood 12 x 12 x 6mm
6
Hard wood 12 x 12 x 6mm
Must be purchased
separately!
Hard wood block
mount for servo.
lncluded with
the radio set.
A
B
Flap
Flap Servo
L
R
Drill two 2mm holes on where control horn will be
mounted as shown in picture.
Then insert 2x12mm screws through control horn and
flap. Then add the horn base at the underside of flap,
and lock it in place. Then connect adjusters to both
ends of the 2mm threaded pushrod. Attach one end to
control horn, adjust to suitable length and then
connect to servo arm. Check the angle between servo
arm and pushrod. Assemble control horns on both
sides the same way.
2mm
2 x 12mm
2 x 60mm Rod
4
3 x 4 mm Set Screw
1
3
4.1mm Collar
Fixed Landing Gear
Insert M4 collar to the 4mm landing gear and insert to
the hard wood mount, adjust to suitable length and
lock in place with 3x4mm set screw.
Then attach the steering arm and lock it at suitable
direction with the 3x4mm set screw. Then drill a 2mm
hole on the steering arm.
Then insert 4mm nylon ring to the landing gear and
insert the 45mm wheel. Then add the M4 collar and
lock in place with set screw.
45mm
4mm Nylon Ring
1
4.1mm Collar
3 x 4 mm
2mm
4mm Nylon Ring
4.1mm Collar
Attention: Skip to Step#26 if you are using
retractable landing gear.
Assembly for (Micro) Servo
Attach the 12x12x6mm hard wood on servo tray with
A/B glue, then mount servo in place with the screws
supplied with servo.
Note the servo directions for left and right hand,
assemble left & right side the same way.
Note: Servo, servo plate & its parts are NOT included!
To Next Page
Loading...