4) Mount the Tom Toms
Place the TOM TOM ARM (TA) into the TOM TOM MOUNT (4)
and tighten the wing nut loosely until you have decided
exactly where the TOM TOM (T) will rest.
Place the Tom Tom Extension Arm on the right side facing.
You can also place the Tom Tom Extension Arm
on the left side facing. Place the TOM TOM (T) on the Extension Arm
loosely tighten the wing nut and position the TOM TOM (T) in position.
Once the TOM TOM (T) is in the desired position tighten all the wing nuts.
5) Mount the Cymbal Arm
Place the CYMBAL ARM (CA) into the CYMBAL MOUNT (2)
and tighten the wing nut loosely until you have decided
exactly where the CYMBAL (CY) will rest.
Loosen the wing nuts on the CYMBAL ARM (CA) and remove the
Metal Washer and the 2 Cymbal Felt Washers.
Place 1 Cymbal Felt Washer onto the CYMBAL ARM (CA) and place
the CYMBAL (CY) on the Felt Washer. Place the remaining
Felt Washer on top of the CYMBAL (CY), then the Metal Washer on top
of the Felt Washer and hand tighten with the wing nut. Tighten
wing nut on the CYMBAL MOUNT (2) until secure
6) Mount the Snare Drum
Place the TOM TOM ARM (TA) into the TOM TOM MOUNT (4)
and tighten the wing nut loosely until you have decided
exactly where the SNARE DRUM (SD) will rest.
Place the Tom Tom Extension Arm on the left side facing.
Place the SNARE DRUM (SD) on the Extension Arm loosely tighten
the wing nut and position the SNARE DRUM (SD) in position.
Once the SNARE DRUM (SD) is in the desired position tighten all
the wing nuts.
7) Put the Bass Pedal in Place
Now is the time to make sure you have placed the Drum Kit
exactly where you would like it. Loosen the wing nut on the
clamp so you can clamp the BASS PEDAL (P) to the
BASS DRUM RIM (R). Line up the mallet of the BASS PEDAL (P)
so it hits the BASS DRUM HEAD (H) squarely. Once you have it in
place tighten the wing nut on the clamp.
To Next Page
Loading...