20
3 Single Remote Control Erasure
Phase
Description
Example
1
Press and hold the programming button of the MINI-RX until the LED on the receiver performs a
blink and the buzzer performs an acoustic warning.
2 After about 1 second by the release of the button, the LED on the receiver emits ve ashes.
3 Press the button of the receiver during the 5th ash.
4 Push the button on the remote control you want to erase.
5 If cancellation is successful the receiver will emit 5 short ashes and 5 acoustic warnings.
6 To erase another transmitter, repeat step 4
7 To complete the procedure to wait for the 10 seconds time-out
8 End
4 Mode Selection
WARNING Remotes in memory will be deleted.
Phase
Description
Example
1
Press and hold the programming button of the MINI-RX until the LED on the receiver performs a
blink and the buzzer performs an acoustic warning.
Hold down the programming button of the MINI-RX for more than 3 seconds. The LED on the
receiver will perform another blink and the buzzer another acoustic warning.
2
Press the programming button a number of times equal to the mode you want to program:
1 pressure -> Light Control Mode (1 blink and 1 acoustic warning)
2 pressure -> Motor Control Modes (2 blinks and 2 acoustic warnings)
3 pressures -> Roll back to Light Control Mode (1 blink and 1 acoustic warning)
The system will notify the user the selection just made through the LED, with a number of blink
(fast) and acoustic warnings equal to the selected function, repeated every 2 seconds
3
To end the selection, press and hold the programming button.
The LED on the receiver performs a blink and the buzzer performs an acoustic warning.
4 End
To Next Page
Loading...
