Dea LIVI 3/24 - Page 30

28
3 Selection type of operators ! IMPORTANT !
1. Scroll down the parameters with and keys until you visualise
P028;
2. Access the parameter by pressing the key;
3. Verify that the value corresponds to d008 (LIVI 3/24), otherwise, you
must select it by pressing and keys;
4. Conrm your choice by pressing the key (display returns again to
P028).
4 Selection of direction of motion
1. Scroll down the parameters with and keys
until you visualise P063;
2. Access the parameter by pressing the key;
3. Acting on and keys, set:
- d000=motor in standard position (on the left of
the gap);
- d001=motor in inverted position (on the right of
the gap);
4. Conrm your choice by pressing the key (display
returns again to P063).
Warning: The parameter automatically reverses the
motors output open/close.
Warning: Changing this parameter you need to change
the parameters for the opening and closing limit
switches.
5 How to adjust the limit switche
1. Scroll down the parameters untill you visualize
P001;
2. conrm by pressing the key;
3. by pressing (OPEN) and (CLOSE), move the
leaf in the opening position and adjust the limit
switch cam so that it pushes the microswitch in that
point;
Repeat adjusting the closing limit switch.
4. Conrm by pressing the key (display shows again
P001).
6 Motor stroke learning
1. Make sure you have properly adjusted the opening/closing limit switches cams;
2. Scroll down the parameters with and keys until you visualise P003;
3. Access the parameter by pressing the key;
4. When “ ” ashes, continue pressing the key;
5. Release the key when “ ” stops ashing; Start the learning procedure with operator 1 opening;
6. Wait for the door searches and stops on the opening stop and then on the closing stop.
7. Once the procedure is ended, the display will show “- - - - “.