12
04
Apply a small amount of
superglue to the two pegs of the
small front wing supports.
01
Hold one of the two ns of the
front wing with your pliers and
apply superglue to the at bottom, as
shown. Handle the superglue carefully,
applying a small amount.
02
Fit the ns at the indicated
positions on the front wing (see
green arrows). The dashed green lines
show how the two parts should sit.
05
Place the two supports on the
front wing, as shown above (see
green arrows). The dashed green lines
show how the two parts should sit.
06
Place the two large front wing
supports, as shown above.
Use the dashed green lines to nd the
correct position on the front wing.
Position with the wide end of the
supports toward the front of the wing
(see arrows).
03
Using a knife carefully separate
the two small front wing
supports from the moulding. Note: The
two pegs at the ends of the supports
must not be removed.
To Next Page
Loading...