396
03
Viewed from the side, the switch
(outlined in dotted red lines)
should be positioned as shown.
02
Put the switch onto the right chassis plate, with the cable with the black plug
leading towards the rear of the chassis and the ON/OFF slider facing down. Run the
cable as shown, between the right-hand side of the gearbox cover and the front throttle
servo mount, as indicated by the red arrows. The switch’s slider ts into the rectangular cut-
out in the chassis plate (orange arrow).
01
Remove the two screws at the
top of the switch, then take o
the ON/OFF cover plate.
05
To complete this assembly stage,
place the two screws that you
removed in Step 01 into the holes in the
cover plate, and tighten them into the
switch to x it in place.
04
Place the cover plate over the
switch’s slider on the bottom of
the chassis plate, as shown. Note: the
OFF side must be sitting in its position
towards the front of the model.
To Next Page
Loading...
