DECKED TOOL BOX User Manual

DECKED.COM | 208-806-0251 TBFDL | v.1 | Page 1
STEP 1:
Place rubber pads on bed rails.
(1) per side.
STEP 2:
Unless you’ve experienced radiation exposure (allowing
you to mutate into The Hulk) grab a friend to help you lift
the Tool Box into place on top of the rubber pads. Center
the Tool Box L-R between the bed rails and align square
to the bed on both sides.
WARNING
SHIFT TOOL BOX
AS NEEDED FOR
CAB CLEARANCE
STEP 3:
Open the Tool Box lid to be sure it doesn’t hit the cab of truck
under any circumstances. Make sure there is adequate
distance between the lid and any cab mounted cameras,
lights or other important bits.
Shift the Tool Box toward the tailgate as needed.
STEP 4:
Install (2) bed rail clamps on each side of the Tool Box using one location as close to the tailgate as possible and one location
as close to the cab as possible. NOTE: Outermost clamp locations vary per vehicle depending on the topology of the bed rails.
Secure clamps with bolts, washers and nuts in order shown. Tighten all four bolts.
Test tightness by closing Tool Box lid and pulling on the handles, L-R and front to back.
Tool Box should not move on the bed rails.
(2) BOLTS, (2) WASHERS PER SIDE
(OUTERMOST HOLE LOCATIONS
VARY DEPENDING ON VEHICLE)
PLACE RUBBER PAD OVER
INSIDE LEDGE OF BED RAIL
TOOL BOX INSTALLATION
TOOLS NEEDED:
• 3/8” socket
• Ratchet
(2) CLAMPS, (2) NUTS PER SIDE
(OUTERMOST HOLE LOCATIONS
VARY DEPENDING ON VEHICLE)
slide
pull up
SIDE VIEW
TEAM LIFT
REQUIRED
TEAM LIFT
REQUIRED:

DECKED TOOL BOX Specifications

General

Brand	DECKED
Model	TOOL BOX
Category	Automobile Accessories
Language	English

Summary

DECKED TOOL BOX INSTALLATION

STEP 1: Place Rubber Pads

Place rubber pads on the bed rails, one per side, over the inside ledge of the bed rail.

STEP 2: Position Tool Box

With assistance, lift the Tool Box, center it between bed rails, and align it square to the bed.

STEP 3: Check Cab Clearance

Ensure the Tool Box lid clears the truck cab, cameras, or lights. Adjust position as necessary.

STEP 4: Secure Tool Box with Clamps

Install bed rail clamps using bolts, washers, and nuts. Tighten securely and test for stability.

USING THE LADDER

Ladder Operation Steps

Follow the three illustrated steps to correctly attach and use the ladder, ensuring it clicks securely.

Ladder Usage Safety Warning

Warning against improper ladder use that could swing into the truck and cause damage to the vehicle.

DECKED 3-YEAR LIMITED WARRANTY

Warranty Coverage and Exclusions

Details product warranty, what it covers, and common exclusions like misuse, abuse, or normal wear.

Warranty Activation and Claims

Instructions on how to activate the warranty and contact customer service for claims.