DECKEL FP4M - Page 341

1 ndex
- chart of indexing values ......
- clamping the index head spindle
- direct indexing, index pin ....
- eliminating backlash
in worm gearing ...............
- engaging/disengaging the worm .
- function ......................
- horizontal operations .........
- indirect indexing, index plates
- indirect indexing, scale ......
- maintenance ...................
- mounting of ...................
- mounting of clamping fixtures .
- mounting of index plates ......
- mounting of overarm ...........
- pivoting about B axis .........
- tilting about A axís ..........
- technícal data ................
Inspection of machine ...........
Installation of machine .........
L
м
7-79 Machine axes .................... 6-3
7-71
7-71 Machine lamp .................... 3-6
7-82 Machine slide motions
7-70 - manually controlled ........... 5-18
7-64 - power feed .................... 5-29
7-80 - rapid traverse ................ 5-28
7-75 - with digital position readout . 6-3
7-73
7-83 Main disconnect switch .......... 5-1
7-66
7-66 Manual control by handwheels .... 5-18
7-81
7-69 Master switch
7-68 (see 'Maín disconnect swítch')
7-67
1-19 Microdrilling attachment ........ 7-147
- application ................... 7-147
8-1 - feed selection ................ 7-150
- function ...................... 7-148
3-1 - mounting of ................... 7-148
- speed selection ............... 7-149
- technical data ................ 1-35
Lubricating instructions ..... 4-3, 8-1
Lubrication and maintenance ....
- centralized lubrication system
- coolant ......................
- drive be1t, feedbox ..........
- drive be1t, spindle ..........
- general information ........... 8-1
- handwheels ................ 4-3, 8-15
- lubrication schedule .......... 8-2
- maintenance, feedbox ..........
- maintenance, main transmission
- replacíng the cutter spindle ..
- replacing the feedbox .........
- replacing the main transmission
- slideways
- taper gibs
- wipers ...
8-1
8-11
8-12
8-22
8-16
8-6
8-6
8-34
8-25
8-19
8-27
8-30
8-27
0
0i1 (lubrication) ............... 8-1
- oi1 grades .................... 8-1
Oí1 change
- feedbox ....................... 8-8
- maín transmission ............. 8-11
- universal table ............... 7-28
Oi1 1eve1 checks
- centralized lubrication system 4-2
- feedbox ....................... 4-2
- main transmission ............. 4-1
- reduction gearing, univ. table 7-28
- worm gearing, universal table . 7-28
Operating position
- vertical spindle head ... 5-39, 5-41
9-9