DECKEL FP4M - Page 342

lndex
P
Pivotable circular table
- application ...................
- direct indexing, scale ........
- eliminating backlash
in worm gearing ...............
- engaging/disengaging the worm .
- function ......................
- indirect indexing, index plates
- indirect indexing, scale ......
- maintenance ...................
- mounting of ...................
- pivoting about B axis ......... 7-43
- swivelling about C axis ....... 7-45
- technical data ................ 1-15
- tilting about A axís .......... 7-42
- setting the depth of cut
7-37 Ьy scale ...... ......... ... 7-140
7-46 by slíp gauges (gage blocks) .. 7-141
- spindle speed selection ....... 7-136
7-51 - technical data ................ 1-33
7-44
7-40 Preparatory operations .......... 4-1
7-49
7-46
7-52
7-41
Pivotable swível table
- applicatíon ................... 7-29
- direct indexing, index pin .... 7-36
- direct indexing, scale ........ 7-35
- function ...................... 7-30
- mounting of ................... 7-31
- pivoting about B axís ......... 7-34
- readjusting the index pin guide 7-36
- swivelling about C axis ....... 7-36
- technical data ................ 1-13
- tilting about A axis .......... 7-32
Position readout
- machine ....................... 6-1
- universal table ............... 7-13
Power feed
- headstock ..................... 5-29
- table slide, horizontal ....... 5-31
- table slide, vertical ......... 5-30
Power requirements, calculation
with DECKEL slide rule ........
Precisíon boring head ...........
- application ...................
- compensation spring ...........
- function ......................
- maintenance ...................
- manual feed, coarse ...........
- manual feed, fine .............
- mode of feed ..................
- mounting of ...................
- mounting of tools .............
- overload clutch ...............
- power feed ....................
5-25
7-133 S1ide rule ............ 5-9, 5-23, 5-25
7-133 - English version ............... 5-11
7-144
7-134 Slotting head ................... 7-127
7-145 - application ................... 7-127
7-139 - function ...................... 7-128
7-139 - maintenance ................... 7-132
7-137 - mounting of ................... 7-128
7-135 - mounting of tools ............. 7-129
7-136 - pivoting of ................... 7-131
7-144 - stroke length ................. 7-130
7-138 - technical data ................ 1-31
R
Rapid traverse .................. 5-28
Reduction ratios
- circular table ................ 7-57
- pivotable circular table ...... 7-49
- universal table ............... 7-12
Reference point
- machine ....................... 6-7
- universal table ............... 7-16
Rest position, vertical
spindle head ......... 5-40, 5-42, 5-43
Rough millíng ................... 5-14
S
S1ide motions
(see 'Machíne slide motíons')
9-10