1. Remove the exterior and interior packaging, and then check that all accessories are included. If
any parts are missing, please contact our customer service.
2. Remove all the tape on the unit; take out the accessory parts inside.
3. Clean the interior with lukewarm water and a soft cloth.
4. Place your ice maker on a level counter table far from direct sunlight and other sources of heat
(i.e. stove, furnace, and radiator). Make sure that there is at least 6 inches between the back and
sides of your ice maker with the wall.
5. Allow one hour for the refrigerant fluid to settle down before plugging your ice maker in.
6. The power plug must be accessible directly.
WARNING: fill with potable water only. Only use drinking water.
*Improper use of a grounded plug can result in the risk of electrical shock. If the power cord
is damaged, please call our customer service.
1. This unit should be properly grounded for your safety. The power cord of this appliance is equipped
with a grounding plug which connects with standard grounding wall outlets to minimize the possibility
of electric shock.
2. Plug your appliance into an exclusive, properly installed, grounding wall outlet. Do not under any
circumstances; damage the grounding means of the plug. Any questions concerning power and/or
grounding should be directed toward a certified electrician.
3. This appliance requires a standard 110-120Volt, 60Hz electrical outlet with good grounding means.
Before using your ice maker it is strongly recommended to clean it thoroughly.
Unplug the unit before cleaning or performing any maintenance.
1. Move the machine to the edge of the counter top, remove the drip tray, then put a container under
the desktop, unplug the water drain cap 1&2 to drain the water inside the unit.
2. Reinsert the water drain cap 1&2, turn the back of the unit toward you, take out the water reservoir.
3. Then use the water to rinse the inside parts, and drain out the water by unplugging the drain cap on
front bottom side.
4. The outside of the ice maker should be cleaned regularly with a mild detergent solution and warm
water.
5. Dry the interior and exterior with a clean soft cloth.
6. When the machine will not be in use for an extended time, drain the water completely and dry the
interior.
OPERATING PROCEDURES & MAINTENANCE
To Next Page
Loading...