Deco Chef DGADIMN01 - Troubleshooting

PROBLEM
POSSIBLE CAUSE
SOLUTION
“Add Water”
indicator lights up
Lack of Water.
Press “ON/OFF” button to stop the
ice maker, fill water, and press
“ON/OFF” button again to restart
the unit.
“Ice Full”
indicator lights up
or flash
There is too much ice.
Suggest you to obtain the
ice-cube.
(No ice cube inside).
Verify by a qualified technician.
“ Ice” indicator
lights flash
The system is attempting to resolve
its issue
It will automatically resume work.
When this problem occurs
frequently, please clean the
machine carefully.
“ Ice” indicator
lights flash and
button turn red
Ambient temperature or water
temperature in inner tank is too high.
Please run the ice maker below
90 Fahrenheit degree ambient
and pour colder water into tank.
Refrigerant liquid leakage.
Press the ICE button twice, restart
ice making program, if this
problem show up again, verify
by a qualified technician.
Cover motor is broken
Pipe in the cooling system is
blocked.
“ Ice” & “ Add
Water” indicator
lights flash and
button turn red
Water pump or float switch or water
valve doesn’t work
Verify by a qualified technician.
Making Ice too
slowly
Hot Air outlet has been blocked by
something.
Hot Air outlet must be guaranteed
to have more than 15 CM of
ventilation distance.
Water temperature in inner tank is
too high.
Water temperature requirement
between44F-89.6F.
Refrigeration system malfunctions.
Verify by a qualified technician.
Water leakage
Drain plug not in place
Put the drain plug in place.
Pipe Joint in the appliance may
Loose
Verify by a qualified technician.
The seal has reached service life
Verify by a qualified technician.
TROUBLESHOOTING