Plug in the power cord and the screen will turn on. You can operate this appliance by pressing the button on
panel as shown above. The main status indicators are below for reference:
Standby: "ON/OFF" button flashes white
Ice making: "ON/OFF" button flashes blue and white alternately, "ICE" indicator is on.
Water shortage (during ice making): "ADD WATER" indicator is on and "ICE" indicator is on
simultaneously, "ON/OFF" button flash white and red alternately.
Clean: "ON/OFF" spins in blue, "CLEAN" indicator is on.
Water shortage (during cleaning): "ADD WATER" indicator is on, "CLEAN" indicator is on
simultaneously, "ON/OFF" button flash blue and red alternately.
Add water abnormal: "ADD WATER" and "ICE" indicator flash simultaneously, "ON/OFF" button flashes
red. For this, refer to the troubleshooting section.
CLEANING
Prior to the machines first use, or if the cleaning procedure has not run for a while, it is
highly recommended to run this procedure.
4. Before the cleaning procedure, first unplug the water drain cap 1&2 to drain the water inside
the unit completely. Then make sure the water drain caps have been inserted into the
unit again. Otherwise water inside the unit may overflow. Then fill the water reservoir with more
than half of its capacity
5. Press “ON/OFF” button for 5 seconds, the “CLEAN” indicator will turn on. It will run the cleaning
procedure for 10 minutes and automatically stop. Press this button again during cleaning and it will
stop the cleaning mode immediately.
TIPS: If the unit has not been used for a long time (more than one month) and has not
been cleaned, or the unit doesn’t work after a few months, add some vinegar, acetic acid into
the water to remove scale before cleaning. After the cleaning procedure, wait for 30
minutes, allow the scale to dissolve fully, then drain the water inside the unit completely.
Add water and run cleaning procedure again.
6. After the cleaning procedure, move the back of the machine toward you remove the water reservoir
and clean the water tank inside the unit with a brush or cloth. Then move the appliance to the edge of
the counter top and make sure that the appliance is placed steadily. Place a water container under
the appliance and remove drain cap from the bottom. Dirty water will drain into the water container.
Reinsert the drain cap.
To Next Page
Loading...
