DeDietrich AWHP MIT-IN iSystem User Manual

User level - Menu #MEASURES
Parameter Description Unit
OUTSIDE TEMP.
Outside temperature °C
ROOMTEMP. A
(1)
Room temperature of circuit A °C
ROOMTEMP. B
(1)
Room temperature of circuit B °C
ROOMTEMP. C
(1)
Room temperature of circuit C °C
TEMP.MIT
Inside module flow sensor measurement °C
PRESSURE
Water pressure in the installation bar
WATER TEMP.
(1)
Water temperature in the DHW tank °C
STOR.TANK.TEMP
(1)
Water temperature in the storage tank °C
SWIMMING P.T.B
(1)
Water temperature of the swimming pool on circuit B °C
SWIMMING P.T.C
(1)
Water temperature of the swimming pool on circuit C °C
OUTLET TEMP. B
(1)
Temperature of the flow water in circuit B °C
OUTLET TEMP. C
(1)
Temperature of the flow water in circuit C °C
SYSTEM TEMP.
(1)
Temperature of the system flow water if multi-generator °C
T.DHW BOTTOM
(1)
Water temperature in the bottom of the DHW tank °C
TEMP.TANK AUX
(1)
Water temperature in the second DHW tank connected to the AUX circuit °C
DHW A TEMP.
(1)
Water temperature in the second DHW tank connected to circuit A °C
TEMP.SOL.TANK
(1)
Temperature of the hot water produced by solar power (TS) °C
SOLAR.COLL.T.
(1)
Solar panel temperature (TC) °C
SOLA.ENERGY
(1)
Solar energy accumulated in the tank kWh
FLOWMETER
Plate exchanger flow rate l/min
NB IMPULS.COMP
Number of heat pump start-ups
RUNTIME HP
Number of hours' operation of the heat pump compressor h
IN 0-10V
(1)
Voltage at input 0-10 V V
SEQUENCE
Control system sequence
CTRL Software control number (SCU)
(1) The parameter is only displayed for the options, circuits or sensors actually connected.
4. Operating the appliance AWHP MIT-IN iSystem
15
06/09/2012 - 300027618-001-01

DeDietrich AWHP MIT-IN iSystem Specifications

General

Brand	DeDietrich
Model	AWHP MIT-IN iSystem
Category	Heat Pump
Language	English