(Fig.7)
4.3 Operating Of The Unit
14
1
2
3
4
5
M
Heating
Smart
Smart
Mode
INNOVATION FOR LIFE
6
789
①
②
“5” is the on/off button, when press , water heater start working , display screen will be lighted
up. Then press again, electricity will be cut off, and display screen will be shut down .
③
“7” and “8” are temperature adjustment buttons. Temperature increases when pressing “7”
button, and decreases when press “8” button. During the adjustment , display screen " 4" will
change accordingly. When temperature setting meets customers' requirements, stop
adjusting and display screen "4" will flash for around 3 seconds, which means temperature
has been set successfully. After flashing ,display screen "4" value will return to current inner
water heater temperature.
“1” button is for frequency switch. When press firstly, display screen “6” will show the three�
frequency option( index number “1” means 1200W, index number “2” means 2000W , index
number “5” means high temperature sterilization mode).
④
"6" is for frequency display. If number " 1" comes out , it means 1200W(only one tank is
heating ) ; If number "2" comes out , it means 2000W (the two inner tank has been being
heated up ) ; If number "3" comes out , it means energy saving mode, the temperature is set
to 55℃ and cannot be adjusted ; If number "4" comes out , it means smart control energy
saving mode, the water temperature is automatically changed. The appliance works to
reduce the electricity energy of the user consumption, which allows heat loss to be minimized
and energy savings to be maximized; If number "5" comes out , it means high temperature
sterilization mode ,The fixed setting temperature is 80 degrees, and heating starts when the
temperature is lower than this temperature. The heating temperature will keep 80 degrees,
for 5 minutes , then exit the bacteriostasis and return to the default mode.
⑤
From “3” , customer could tell heating status.The light “2” will long bright , when energy
saving mode is started.The light “2” will blink , when smart control energy saving mode is
started , According the temperature set, the light “3" will be turned on which means water
heater is being heated. When inner water heater temperature reaches the set value, light “3"
will turns off , which means water heater enter into warm-keeping status.
⑥
⑦
"4" could show the current inner water temperature as well as set temperature value. If no
person operates on water heater , the value in display screen " 4" means current temperature
value. By pressing button “7” or “8” , "4" values will vary accordingly . When finish temperature
setting , "4" values will return back to actual current inner water heater temperature.
When press “9” button, the temperature value will be set to 55℃ straightly, enter energy
saving mode. When press “9” button for 3 second , the water temperature is automatically
changed, enter smart control energy saving mode.
To Next Page
Loading...
Need help?
General
