35
1- Select the "START CONTROL" cooking zone by pressing
on the button after having turned on your hob. The
[ ] symbol
is displayed.
3- Set the cooking end time and duration *
for example 14.00 (= 2 pm) and 10 mins
The symbol begins flashing, and the clock lights up. Adjust the
cooking end time by pressing on the + button on the timer (or on the -
button to reduce it). To adjust the duration, press on the button
and the timer symbol begins flashing. Adjust using the - or +
buttons on the timer.
Use the button to change from one setting to another.
After five seconds without pressing the buttons, a beep confirms your
choice of programming, the and control symbols flash on and
off alternately, on the hob the start indicator goes out and the other
indicator begins flashing (approximately 2 flashes every 5 seconds).
2-
Press on the “START CONTROL”
button.
5- Modifications
If the "START CONTROL" is selected:
At any time you can modify the parameters (power, duration, end time) by pressing on the appropriate
buttons.
To cancel the programming all you need to do is turn off the oven,
via a long press on the button.
0
11
14h00
10
14h00
4- Power
Power setting 4 is automatically proposed to you. You can adjust this
according to your needs, (maximum 6).
If you have adjusted your power setting (example: 11) before pressing on
the "START CONTROL" button, the power will be adjusted to the maximum
authorised (6) the moment that you carry out "start control" adjustment.
10
6
BIP..BIP
Programme adjustment
NOTE
- If your duration reaches 0, turn off the heating zone and then reprogram "START CONTROL".
- * If after few seconds you do not make a choice between the two parameters, the "start control"
mode is rejected.
Using your hob in all simplicity
To Next Page
Loading...
Need help?
General
