Using a Screwdriver, remove the fixing screw, push the Battery Cover out of
the bottom of the transmitter, and Insert 4 AA batteries.
< RC CAR’S DETAILS >
< TRANSMITTER FUNCTIONS >
< BATTERY INSTALLATION >
ON/ OFF
Power Switch
Battery Cover
Battery Cover Lock
Steering Control Wheel
Throttle Trigger
Battery Cover
ON/ OFF
Power Switch
Indicator Light
1. RC Car Battery
2. Transmitter Battery
① Remove the screw from the battery cover with a screwdriver to open the
battery cover.
② Put the battery into the battery compartment.
③ As shown in the diagram above , connect the battery cable to the cable in
the battery compartment.
ĺClose the battery cover.
Always pay close attention to battery polarity when installing the
batteries to make sure they are fitted correctly.
4 x 1.5V AA
(Not included)
Battery Cover
When the transmitter is not used for a long time, please turn off the
power and take out the battery.
Trimmer Knob
To Next Page
Loading...