Pull the throttle trigger backward, the car goes forward. The amplitude of the
trigger controls the speed of the RC car.
Push the throttle trigger forward, the car goes backward. The speed of the RC
car can be controlled by the amplitude when the trigger is pushed.
< CHARGING >
USB Adapter
(5V @ 0.5-2.0A)
Power Bank
Computer USB Port
< OPERATION >
Turn on the power switch of the RC car and the transmitter respectively to
operate the RC car. During the pair, the RC car indicator light will blink. When
the indicator light turns solid, it is mean that the RC car pair successful. After the
pairing is finished, the RC car can be operated.
2. Forward
3. Backward
1. Pairing
The battery is a new battery pack and it is recommended to be recharged
before use.
1. Plug the USB charging cable into a USB charging port on the computer,
power bank or USB adapter (5V@ 0.5~2.0A).
2. Connect the wire of battery with USB charging cable.
3. Charging time: about 240 minutes.
4. The red indicator light on the USB charging cable will flash when the
battery is under charging, and will turn off when the battery is fully charged.
( If you find that the battery pack and USB charging cable are damaged, stop
using it immediately and replace the accessories as soon as possible.)
ATTENTION:
Please keep the battery in sight for charging. Do not put the battery on the
flammable surface.
When the battery of the RC car is low or not used for a long time, please
turn off the power of the car, disconnect the battery from the RC car, and
charge the battery in time to prolong the battery life.
●
●
Pull
Push
To Next Page
Loading...