Pen use
1. Rotate the power cord hooks on the handle to quickly disconnect the
power cord.
2. Open the buckle from the fixing block on the metal tube, pull out the
metal handle completely, and then clamp the buckle at the
corresponding position of the main handle of the machine.
3. Rotate the floor brush slowly and firmly, and remove the floor brush
after the floor brush relaxes.
4. Insert the brush head into the suction port in the direction of the arrow
as shown in the figure (4).
5. Insert the plug into the socket and make sure the connection is
secure. Set the power switch on the machine body to the "1" (ON)
position, and the vacuum cleaner will start working.
6. Set the power switch to the "0" (OFF) position and remove the plug
from the outlet.
7. Press the dust-panel frame switch, take the dust-panel frame
together with the strainer, and then take out the strainer to put the
debris in the dust-panel frame into the waste container.
Release
the cord
Remove
the dust
Start the
vacuum cleaner
Turn off the
vacuum cleaner
Install a lint brush
Take out the
floor brush
Remove the
power handle
To Next Page
Loading...
