5
SINGLE WAVELENGTH : Repeatedly press and release Button F until the
desired wavelength is selected (this single wavelength will be delivered for the entire
treatment duration) then go to step 7.
DUAL - WAVE : Repeatedly press and release Button E until the desired wavelength
combination is selected (these two wavelengths will be delivered together for the entire
treatment duration) then go to step 7.
TRI - WAVE : Repeat step 4 and step 5. The three wavelengths selected, will cycle in
sequence as single colours for 2 minutes (wavelength 1), 2 minutes (wavelength 2) then
one minute (Near Infrared - NIR), until the end of the programme.
Set the desired treatment duration. Button G will decrease treatment time (minimum
5 minutes) whilst Button H will increase it (maximum 60 minutes). The recommended
treatment duration is 20 - 30 minutes, and can be used daily if required.
Connect the appropriate end of the ‘electricity supply cable’ (see page 3) into power cable
Port C at the front of the control panel, and plug the opposite end into the electric wall socket
or adapter, Light B will illuminate, indicating that power is being supplied to the control panel.
Connect the appropriate end of the ‘mask to control panel cable’ (see page 3) into Port A at
the front of the control panel, and the opposite end into Power supply Port 4 found at the chin
of the Mask
Press and hold Button D for 2-3 seconds, and release when you hear a short melody.
The LCD screen on the top of the control panel will illuminate. The control panel is now ready
for programming.
DÉESSE PRO
INSTRUCTIONS FOR USE
To Next Page
Loading...