Automatic functions
Rearming: If you turn the alarm off, but do not open doors, hood/bonnet or luggage compartment, the
alarm turns itself ON automatically after 60 seconds. In the case of cars with central locking, the doors
are also locked.
Open door indicator: If doors, hood/bonnet or luggage compartment are opened while the ignition is
turned on, the LED ashes rapidly for 10 seconds to warn you. If this happens while you are driving, it
may indicate a faulty or incorrectly adjusted door, hood or luggage compartment switch.
Passive arming: The alarm may be programmed to turn itself on automatically 12 seconds after the
last door has been closed when you have parked. This function is not activated as a default setting. If
you wish this function to be reprogrammed, you must contact an authorised installer.
Automatic interior lights: When dearmed, the alarm will light the interior lights for 30 seconds, or until
the ignition is turned ON. This function is not available for some car models.
Automated activation of the immobiliser function:
· Activation coincide with the reactivation of the alarm, 60 sec. after an alarm deactivation.
· Activation ca. 55 sec. after a door has been opened.
· No activation occurs if ignition is left to ON position.
· If the alarm is deactivated, a door is opened and shut, the ignition is turned on and off, the
immobiliser will not activate until a door is opened again.
· If the alarm is deactivated and the immobiliser is active the LED will blink twice in sequence.
What triggered the alarm?
The LED indicates the sensor that triggered the alarm.
Alarm triggered by: Number of ashes:
Auxiliary sensor 1 2
Opened door 3
Opened bonnet/hood 4
Opened trunk/Luggage compartment 5
Ignition 6
Attempt to remove protected equipment (car stereo, roof box e.g) 7
Microwave sensor 8
Glassbreakage sensor 9
Auxiliary sensor 2 10
The ash sequence stops when the ignition is switched ON or the alarm is armed.
To Next Page
Loading...
