4
TRIGGERING ALARM
When armed, the system will monitor all doors, trunk, hood and ignition. If tted with appropri-
ate sensors, the system can also monitor glass breakage, interior motion and vehicle tilting.
Triggering
If any of the sensors detect an alarm condition, the siren will sound for 30 seconds and the
direction lights will ash for 2 minutes.
Note! The sensor inputs are restricted to maximum 10 triggers per arming cycle.
ALARM TRIG MEMORY
When deactivating the alarm system, before the ignition is turned on, the LED will give you
information on what caused the alarm condition.
Note! The ash sequence stops when the ignition is turned on or the system is armed.
When the alarm has been triggered during the last activation period, it will respond with 5
short sound and light signals when deactivated. The LED indicates which sensor that triggered
the alarm by blinking in sequence.
TROUBLESHOOTING
The alarm is meant to operate without need of any kind of servicing. If service after all is
needed; Read the fault nding procedure below before contacting authorized DEFA-dealer.
FAULT CAUSE REMEDY
Alarm system
not responding.
Alarm fuse defect.
Vehicle out of battery.
Replace broken fuse with new one.
Charge battery of the car.
Use e.g. DEFA MultiCharger 1204.
Remote control
not functioning.
Remote control out of battery. Replace old battery with new one.
Trig source: No. of ashes:
Level sensor 2
Door 3
Hood 4
Trunk 5
Trig source: No. of ashes:
Ignition 6
Auxiliary input 7
Motion sensor 8
Glass breakage sensor 9
To Next Page
Loading...
