CARE AND MAINTENANCE
1. Switch off the power at the wall socket. Do not touch the plug with wet hands
2. Close the water tap after the completion of the wash cycle.
3. Wipe the inside of the wash drum and rubber door seal with a soft dry cloth after
completion of the wash.
4. Should the cabinet need cleaning, wipe it with a soft damp cloth. Do not use abrasive
powders, solvents or scouring pads.
5. Traces of old detergent in the detergent dispenser should be removed periodically as
these could obstruct the flow of water into the machine.
The detergent drawer may be removed to
facilitate cleaning and rinsed under a stream
of hot tap water.
Remove the drawer as follows:
1. Pull the drawer out until it stops against
the built in lip at the back of the drawer.
2. A firm action is required to push the bottom of the drawer upwards far enough for the
lip to clear the frame whilst simultaneously pulling the drawer free from the machine.
3. After rinsing, replace the drawer by first locating the lip behind the frame and then
sliding the drawer into the guide channels on either side until it is closed.
ON NO ACCOUNT USE BENZENE OR OTHER SOLVENTS TO CLEAN THE
CABINET, DOOR OR RUBBER OF THE MACHINE. A DAMP CLOTH WILL
NORMALLY SUFFICE OR IF DESIRED A GOOD WAX POLISH MAY BE
USED ON THE METAL PARTS OF THE CABINET
DETERGENT DRAWER
PULL OUT
PUSH LIP UP
To Next Page
Loading...
Need help?
General