Page 7
Warning: Never dispose of
the Refrigerator in a fire.
Do not dispose of your
Refrigerator along with
regular household waste.
Contact local authorities
for disposal information
and facilities available.
Transportation instructions
1.The refrigerator must be transported only in an
upright position. Keep packing intact during
transportation.
2. When positioning the refrigerator, take care not to
damage flooring, pipes, wall coverings etc. Do not
move the refrigerator by pulling the door or handle.
When re-transporting your refrigerator
• The refrigerator must be emptied and cleaned
prior to any transportation.
• The shelves, accessories, crisper etc.
In the refrigerator must be fastened securely with
adhesive tape to protect against any jolts.
• Packaging must be tied with thick tape and strong
rope and the transportation guidelines printed on
the package must be followed.
Placing and Installation
3
1. Install the refrigerator in a place that allows for
ease of use.
2. Keep refrigerator away from heat sources
such as
stoves, geysers
, humid places and direct sunlight.
3. There must be appropriate air ventilation around
the refrigerator in order for efficient operation. The
refrigerator must have at least a 5 cm space from
the ceiling and at least a 5 cm space from the wall.
Fit the Two plastic wall spacers supplied with the
appliance rotating 1/4 turn to the condenser at the
back of the appliance (See Diagram).
When operating your refrigerator for the first time,
please observe the following instructions during
the initial six hours:
• The door should not be opened frequently.
• The refrigerator must be operated empty without
any food in it.
• Do not unplug your refrigerator.
• Original packaging and foam materials should be
kept for any future transportation or moving.
The manufacturer shall not be held liable if the
information given in the instruction manual is not
followed.
If the floor is covered with a carpet, your
refrigerator must be elevated 2.5 cm from the floor.
Your refrigerator must be installed at least
30 cm away from heat sources such as
hobs, ovens, central heaters and stoves
and at least 5 cm away from electrical
ovens and should not be located under
direct sunlight.
If two refrigerators are to be installed side
by side, there should be at least 8 cm
distance between them.
4. Place your refrigerator on an even floor surface to
prevent jolts.
5. Do not keep your refrigerator in ambient
temperatures under 10°C.
Ensure that the interior of your refrigerator is cleaned
thoroughly.
Before using the refrigerator check that:
1. The feet have been adjusted for perfect levelling.
2. The interior of the refrigerator is clean and dry.
3. Check the required distance between your
refrigerator and the wall in order to allow for free
air circulation.
4. The plug has been inserted into the wall socket
and the electricity is switched on. When the door is
open the interior light will come on.
5. There may be a noise as the compressor starts
up. The liquid and gases sealed in the refrigeration
system may also give rise to noise, even if the
compressor is not running, this is normal.
6. Do not load the refrigerator immediately after it is
switched on. Wait until the correct storage
temperature has been reached.
Electrical connection
Connect your refrigerator to a grounded socket which
is protected by a fuse with the appropriate capacity.
Important
The connection must be in compliance with national
regulations.
The power cable plug must be easily
accessible after installation. The specified voltage
must be equal to your mains voltage.
To Next Page
Loading...
Need help?
General
