Page 10
Do not connect the ducting system of the
hood to any existing ventilation system
which is being used for any other appliances
burning gas or other fuels.
The bending of ventilation tube must be
120°, parallel or above the start point and
must be connected to the external wall.
After installation, make sure that the
extractor is level to avoid grease collection at
one end.
Note: Before installation, please
ensure the area is clean to avoid
suction of the remaining bits of
broken wood and dust.
Should you require them, factory
approved, carbon pad filters and
installation kits may be purchased
from your nearest Defy Service
Centre or their authorised agents.
To Next Page
Loading...
