Page 9
The cooker hood can be used on air
recycling mode with a carbon filter. (Not
supplied)
How to install the carbon filter:
x Remove the al filter
x Insert the carbon filter in the rectangular
hole, fitting it over the motor.
x After inserting the front edge of the carbon
filter into the slot on the cooker hood.
Lower the back edge of the carbon filter,
until it clicks into place at the rear the
rectangular hole. Raise the two fixing
bars, until they are horizontal over the
carbon filter.
x Place the Al filter back into position.
x Follow the reverse procedure to uninstall
the carbon filter.
To Next Page
Loading...
Need help?
General
