Defy DDW178 - Starting the Programme; Cancelling the Programme; Salt Indicator ( )

35
EN
the time delay key until the
3-6-9 hours duration indicators
disappear. Time Delay mode will
be cancelled and the programme
selection mode will be activated.
Changng the settngs whle Tme
Delay functon s actve
Whle the Tme Delay functon s
actvated, you cannot make changes
n the washng programme, auxlary
functons or the duraton of delay tme.
To cancel the Tme Delay functon
1. Press and hold Start/Pause/
Cancel key for 3 seconds. Time
delay period and start/pause icon
will start to flash and Time Delay
function will be cancelled.
C You can select and start a
new programme following
the cancellation of Time Delay
function.
C Time Delay function cannot be set
after the programme starts.
Startng the programme
To start your machne after selectng
the programme and auxlary functons,
press Start/Pause/Cancel key.
C Your machine performs water
softening depending on the
hardness level of the supply water.
Due to water softening process the
programme duration may change.
The programme duration can also
change while the programme is
running depending on the ambient
temperature where your machine
is installed, temperature of the
supply water and amount of the
dishes.
C Pay attention not to open the door
of the machine when it is running.
Stop the machine by pressing
Start/Pause/Cancel key if you
have to open the door. Then, open
the door of the machine. There
may be a rush of vapour when you
open the door of your machine;
be careful. Close the door of your
machine and press Start/Pause/
Cancel key again. Programme will
resume running.
C The machine will remain silent
in pause mode for some time
in order to remove the water in
the machine and on the dishes
completely and to have the water
softener cleaned, and then it will
resume running in drying mode.
Cancellng the programme
1. Press Start/Pause/Cancel key for 3
seconds to cancel the programme.
2. Release the key when the
programme indicator starts
flashing. For a couple of minutes
the machine will fulfill the
necessary operations required to
cancel the programme.
C There might be residues of
detergent or rinse aid in the
machine and/or on the pieces
being washed depending on the
step the programme you have
cancelled was in.
Salt ndcator ( )
Please check the salt ndcator on
the dsplay to see whether there s
adequate amount of softenng salt
n the dshwasher or not. You need
to refll the salt reservor wth salt
whenever salt ndcator appears on
the dsplay of your machne.
C Adjusting the water hardness
level is explained in Water
Softening System section.